diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h
index 9db3104562..6acbfa49f0 100644
--- a/Marlin/Configuration.h
+++ b/Marlin/Configuration.h
@@ -1,3 +1,6 @@
+#define UBL
+//#define FILAMENT_RUNOUT_SENSOR
+
 /**
  * Marlin 3D Printer Firmware
  * Copyright (C) 2016 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
@@ -861,7 +864,7 @@
  * For other boards you may need to define FIL_RUNOUT_PIN, FIL_RUNOUT2_PIN, etc.
  * By default the firmware assumes HIGH=FILAMENT PRESENT.
  */
-//#define FILAMENT_RUNOUT_SENSOR
+
 #if ENABLED(FILAMENT_RUNOUT_SENSOR)
   #define NUM_RUNOUT_SENSORS   1     // Number of sensors, up to one per extruder. Define a FIL_RUNOUT#_PIN for each.
   #define FIL_RUNOUT_INVERTING true // set to true to invert the logic of the sensor.
@@ -907,6 +910,7 @@
  *   leveling in steps so you can manually adjust the Z height at each grid-point.
  *   With an LCD controller the process is guided step-by-step.
  */
+
 //#define AUTO_BED_LEVELING_3POINT
 //#define AUTO_BED_LEVELING_LINEAR
 #if(!ENABLED(UBL))