diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h
index c2d5dced28..87fab7852b 100644
--- a/Marlin/Configuration.h
+++ b/Marlin/Configuration.h
@@ -1469,6 +1469,7 @@
   #define FIL_RUNOUT_ENABLED_DEFAULT true // Enable the sensor on startup. Override with M412 followed by M500.
   #define NUM_RUNOUT_SENSORS   1          // Number of sensors, up to one per extruder. Define a FIL_RUNOUT#_PIN for each.
 
+  #define FILAMENT_RUNOUT_DEFAULT_MODE {1} // Array set that will take the place of FIL_RUNOUT_STATE and FIL_RUNOUT_ENABLED_DEFAULT as this code matures
   #define FIL_RUNOUT_STATE     LOW        // Pin state indicating that filament is NOT present.
   #define FIL_RUNOUT_PULLUP               // Use internal pullup for filament runout pins.
   //#define FIL_RUNOUT_PULLDOWN           // Use internal pulldown for filament runout pins.
@@ -1510,13 +1511,13 @@
 
   // Commands to execute on filament runout.
   // With multiple runout sensors use the %c placeholder for the current tool in commands (e.g., "M600 T%c")
-  // NOTE: After 'M412 H1' the host handles filament runout and this script does not apply.
+  // NOTE: After 'M591 H1' the host handles filament runout and this script does not apply.
   #define FILAMENT_RUNOUT_SCRIPT "M600"
 
   // After a runout is detected, continue printing this length of filament
   // before executing the runout script. Useful for a sensor at the end of
   // a feed tube. Requires 4 bytes SRAM per sensor, plus 4 bytes overhead.
-  //#define FILAMENT_RUNOUT_DISTANCE_MM 25
+  //#define FILAMENT_RUNOUT_DISTANCE_MM {25}
 
   #ifdef FILAMENT_RUNOUT_DISTANCE_MM
     // Enable this option to use an encoder disc that toggles the runout pin