diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h
index b888b991b3..066fad2306 100644
--- a/Marlin/Configuration.h
+++ b/Marlin/Configuration.h
@@ -6,7 +6,7 @@
 
 // Enable this is you have a raptor 2.
 // Selects pin file, runout sensor and stock TMC Drivers automatically
-//#define RAPTOR2
+#define RAPTOR2
 
 /**
  * Enable if you replace the stepper drivers with TMC 2208. Be sure to remove MS3 jumper
@@ -15,14 +15,14 @@
  * you require Linear Advance with a TMC2208 on the extruder!
  * If you have used a UART connection to program the driver to SpreadCycle mode, pease seect that as well
  */
-#define X_2208
+//#define X_2208
 //#define X_SpreadCycle
-#define Y_2208
-#define Y_SpreadCycle // Highly recommended as large prints with high mass can cause layer shifts with stealthchop at high speed
+//#define Y_2208
+//#define Y_SpreadCycle // Highly recommended as large prints with high mass can cause layer shifts with stealthchop at high speed
 //#define Y_4988  // Some machines shipped with 4988 drivers across the board. Set this if you arent sure what you have and all the drivers look identical
 //#define Z_2208 // NOT Recommended! Dual stepper current draw is above the recommended limit for this driver
 //#define Z_SpreadCycle
-#define Z_4988  // Some machines shipped with 4988 drivers across the board. Set this if you arent sure what you have and all the drivers look identical
+//#define Z_4988  // Some machines shipped with 4988 drivers across the board. Set this if you arent sure what you have and all the drivers look identical
 //#define E_2208 // Not Recommended! Stealthchop mode faults with linear advance
 //#define E_SpreadCycle
 
diff --git a/Marlin/Configuration_adv.h b/Marlin/Configuration_adv.h
index 9945fa32bd..a10c6c5cb8 100644
--- a/Marlin/Configuration_adv.h
+++ b/Marlin/Configuration_adv.h
@@ -1361,12 +1361,12 @@
  * Useful to get probe points to exact positions on targets or
  * to allow leveling to avoid plate clamps on only specific
  * sides of the bed.
- * 
+ *
  * If you are replacing the prior *_PROBE_BED_POSITION options,
  * LEFT and FRONT values in most cases will map directly over
- * RIGHT and REAR would be the inverse such as 
+ * RIGHT and REAR would be the inverse such as
  * (X/Y_BED_SIZE - RIGHT/BACK_PROBE_BED_POSITION)
- * 
+ *
  * This will allow all positions to match at compilation, however
  * should the probe position be modified with M851XY then the
  * probe points will follow. This prevents any change from causing