diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h
index 311676e457..f136652150 100644
--- a/Marlin/Configuration.h
+++ b/Marlin/Configuration.h
@@ -49,13 +49,13 @@
 //#define BED_AC
 
 //#define HotendAllMetal
-//#define HotendMosquito // High Tenp Slice Thermistor
+//#define HotendMosquito // High Temp Slice Thermistor
 //#define HotendSemitec //E3D or SLice 300C Thermistor
 //#define HotendSlicePT1000
 //#define HotendCreality
 
 //#define HighPoweredHeater
-#define ExtruderDDX //DDX kit with Linear Rail
+//#define ExtruderDDX //DDX kit with Linear Rail
 //#define ExtruderBMG
 
 //#define FORCE_E_INVERT // Forces E to invert if you installed a DDX kit without the Tinymachines stepper reversal wire
@@ -298,13 +298,13 @@
  */
 #if ENABLED(X_2209_Uart)
   #define X_DRIVER_TYPE  TMC2209
-  #define X2_DRIVER_TYPE TMC2209
+  //#define X2_DRIVER_TYPE TMC2209
 #elif ENABLED(X_2208)
   #define X_DRIVER_TYPE  TMC2208_STANDALONE
-  #define X2_DRIVER_TYPE TMC2208_STANDALONE
+  //#define X2_DRIVER_TYPE TMC2208_STANDALONE
 #else
   #define X_DRIVER_TYPE  A4988
-  #define X2_DRIVER_TYPE A4988
+  //#define X2_DRIVER_TYPE A4988
 #endif
 #if ENABLED(Y_2209_Uart)
   #define Y_DRIVER_TYPE  TMC2209
diff --git a/Marlin/Configuration_adv.h b/Marlin/Configuration_adv.h
index 909df57d09..58cf2d1a0b 100644
--- a/Marlin/Configuration_adv.h
+++ b/Marlin/Configuration_adv.h
@@ -3381,7 +3381,7 @@
  */
 //#define SPINDLE_FEATURE
 #if ENABLED(RAPTOR2) && DISABLED(SKRBoard)
-  #define LASER_FEATURE
+  //#define LASER_FEATURE
 #endif
 #if EITHER(SPINDLE_FEATURE, LASER_FEATURE)
   #define SPINDLE_LASER_ACTIVE_STATE    HIGH    // Set to "HIGH" if SPINDLE_LASER_ENA_PIN is active HIGH
diff --git a/Marlin/src/gcode/gcode.cpp b/Marlin/src/gcode/gcode.cpp
index afc4465d31..7bfef6442c 100644
--- a/Marlin/src/gcode/gcode.cpp
+++ b/Marlin/src/gcode/gcode.cpp
@@ -931,7 +931,8 @@ void GcodeSuite::process_parsed_command(const bool no_ok/*=false*/) {
 
       #if HAS_FILAMENT_SENSOR
         case 412: M412(); break;                                  // Alias to M591
-        case 591: M591(); break;                                  // M591 Configure filament runout detection
+        case 591: M591(); break;
+      #endif                                  // M591 Configure filament runout detection
       #if HAS_SHAPING
         case 593: M593(); break;                                  // M593: Set Input Shaping parameters
       #endif