diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h
index 08db0ba9df..c45c75a39d 100644
--- a/Marlin/Configuration.h
+++ b/Marlin/Configuration.h
@@ -1771,17 +1771,17 @@
 // @section stepper drivers
 
 // For Inverting Stepper Enable Pins (Active Low) use 0, Non Inverting (Active High) use 1
-// :{ 0:'Low', 1:'High' }
-#define X_ENABLE_ON 0
-#define Y_ENABLE_ON 0
-#define Z_ENABLE_ON 0
-#define E_ENABLE_ON 0 // For all extruders
-//#define I_ENABLE_ON 0
-//#define J_ENABLE_ON 0
-//#define K_ENABLE_ON 0
-//#define U_ENABLE_ON 0
-//#define V_ENABLE_ON 0
-//#define W_ENABLE_ON 0
+// :['LOW', 'HIGH']
+#define X_ENABLE_ON LOW
+#define Y_ENABLE_ON LOW
+#define Z_ENABLE_ON LOW
+#define E_ENABLE_ON LOW // For all extruders
+//#define I_ENABLE_ON LOW
+//#define J_ENABLE_ON LOW
+//#define K_ENABLE_ON LOW
+//#define U_ENABLE_ON LOW
+//#define V_ENABLE_ON LOW
+//#define W_ENABLE_ON LOW
 
 // Disable axis steppers immediately when they're not being stepped.
 // WARNING: When motors turn off there is a chance of losing position accuracy!