Bump

Marlin/Configuration.h

@@ -16,8 +16,8 @@
 //#define MachineCR10
 //#define MachineCR10S
 //#define MachineCR10SPro // Graphics LCD Requires soldering R64 and R66
-#define MachineCRX
-//#define MachineCR10Max
+//#define MachineCRX
+#define MachineCR10Max
 //#define MachineS4
 //#define MachineS5
 
@@ -35,10 +35,9 @@
 //#define GraphicLCD //Full graphics LCD for Ender 4, CR-X or CR10SPro
 //#define ForceCRXDisplay
 #define Force10SProDisplay
-#define TM3DTouchscreenUpdates // Enables TM3D Error screens and eeprom screen not found in Creality screen firmware
 //#define AddonFilSensor //Adds a filamnt runout sensor to the CR20 or Ender 4
-#define lerdgeFilSensor //Using lerdge filament sensor, which is opposite polarity to stock
-#define DualFilSensors //Using dual filament sensors on XMax and YMAX
+//#define lerdgeFilSensor //Using lerdge filament sensor, which is opposite polarity to stock
+//#define DualFilSensors //Using dual filament sensors on XMax and YMAX
 //#define SKR13 // 32 bit board - assumes 2208 drivers
 //#define SKR13_2209
 //#define SKR13_UART // Configure SKR board with drivers in UART mode
@@ -100,7 +99,7 @@
 */
 //#define ABL_EZABL // TH3D EZABL or Any NO Sensor
 //#define ABL_NCSW //Creality ABL or Any NC Sensor
-#define ABL_BLTOUCH
+//#define ABL_BLTOUCH
 
 //#define CREALITY_ABL_MOUNT //Using creality ABL mount
 //#define E3D_DUALFAN_MOUNT // Using HD Modular mount as above with 2 5015 blowers and sensor on the right
@@ -2601,7 +2600,7 @@
   #define MINIPANEL
 #elif ENABLED(MachineCR20)
   #define MKS_MINI_12864
-#elif NONE(MachineCR10SPro, MachineCRX, MachineEnder5Plus, OrigLCD) || ENABLED(GraphicLCD)
+#elif NONE(MachineCR10SPro, MachineCRX, MachineEnder5Plus, MachineCR10Max, OrigLCD) || ENABLED(GraphicLCD)
   #define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
 #elif ENABLED(OrigLCD)
   #define CR10_STOCKDISPLAY

Marlin/src/lcd/extensible_ui/lib/Creality_DWIN.cpp

@@ -1936,7 +1936,7 @@ void onConfigurationStoreWritten(bool success)
 void onConfigurationStoreRead(bool success)
 {
 	SERIAL_ECHOLN("==onConfigurationStoreRead==");
-    #if HAS_MESH && (ENABLED(MachineCR10SPro) || ENABLED(Force10SProDisplay))
+    #if HAS_MESH && (ANY(MachineCR10SPro, MachineEnder5Plus, MachineCR10Max) || ENABLED(Force10SProDisplay))
         if (ExtUI::getMeshValid())
         {
             bool zig = true;