add graphics lcd and dual z toggles

Marlin/Configuration.h

@@ -6,7 +6,8 @@
 //#define SKR13 // 32 bit board - assumes 2208 drivers
 //#define SKR13_2209
 //#define SKR13_UART // Configure SKR board with drivers in UART mode
-
+#define DUAL_Z
+#define GRAPHICSLCD
 /**
  * Marlin 3D Printer Firmware
  * Copyright (C) 2019 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
@@ -1832,7 +1833,9 @@
 //
 // Note: Usually sold with a white PCB.
 //
-#define REPRAP_DISCOUNT_SMART_CONTROLLER
+#if DISABLED(GRAPHICSLCD)
+  #define REPRAP_DISCOUNT_SMART_CONTROLLER
+#endif
 
 //
 // Original RADDS LCD Display+Encoder+SDCardReader
@@ -1972,7 +1975,9 @@
 // RepRapDiscount FULL GRAPHIC Smart Controller
 // http://reprap.org/wiki/RepRapDiscount_Full_Graphic_Smart_Controller
 //
-//#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
+#if ENABLED(GRAPHICSLCD)
+  #define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
+#endif
 
 //
 // ReprapWorld Graphical LCD

Marlin/Configuration_adv.h

@@ -434,7 +434,9 @@
   #endif
 #endif
 
-//#define Z_DUAL_STEPPER_DRIVERS
+#if ENABLED(DUAL_Z)
+  #define Z_DUAL_STEPPER_DRIVERS
+#endif
 #if ENABLED(Z_DUAL_STEPPER_DRIVERS)
   //#define Z_DUAL_ENDSTOPS
   #if ENABLED(Z_DUAL_ENDSTOPS)
@@ -527,11 +529,13 @@
  * Z Steppers Auto-Alignment
  * Add the G34 command to align multiple Z steppers using a bed probe.
  */
-//#define Z_STEPPER_AUTO_ALIGN
+#if ENABLED(DUAL_Z)
+  #define Z_STEPPER_AUTO_ALIGN
+#endif
 #if ENABLED(Z_STEPPER_AUTO_ALIGN)
   // Define probe X and Y positions for Z1, Z2 [, Z3]
-  #define Z_STEPPER_ALIGN_X { 10, 150, 290 }
-  #define Z_STEPPER_ALIGN_Y { 290, 10, 290 }
+  #define Z_STEPPER_ALIGN_X { 50, 350 }
+  #define Z_STEPPER_ALIGN_Y { 200, 200 }
   // Set number of iterations to align
   #define Z_STEPPER_ALIGN_ITERATIONS 3
   // Enable to restore leveling setup after operation