Allow M206 offsets to apply to z safe home move

Marlin/Configuration_adv.h

@@ -3327,6 +3327,9 @@
 
   #define USER_DESC_3 "Standard"
   #define USER_GCODE_3 "M92E814\nM907E750\nM500"
+
+  #define USER_DESC_4 "Mosquito BMG-M"
+  #define USER_GCODE_4 "M92E814\nM206X5Y15\nM907E750\nM500"
 #endif
 
 /**

Marlin/src/feature/bedlevel/ubl/ubl_G29.cpp

@@ -1555,6 +1555,9 @@
          * numbers for those locations should be 0.
          */
         #ifdef VALIDATE_MESH_TILT
+          #if ENABLED(Z_SAFE_HOMING)
+            constexpr xy_float_t safe_homing_xy = { Z_SAFE_HOMING_X_POINT , Z_SAFE_HOMING_Y_POINT };
+          #endif
           auto d_from = []{ DEBUG_ECHOPGM("D from "); };
           auto normed = [&](const xy_pos_t &pos, const float &zadd) {
             return normal.x * pos.x + normal.y * pos.y + zadd;

Marlin/src/gcode/geometry/M206_M428.cpp

@@ -41,6 +41,12 @@ void GcodeSuite::M206() {
     if (parser.seen(XYZ_CHAR(i)))
       set_home_offset((AxisEnum)i, parser.value_linear_units());
 
+    if (!parser.seen_any()) {
+      SERIAL_ECHOLNPAIR("M206X : ", home_offset[X_AXIS]);
+      SERIAL_ECHOLNPAIR("M206Y : ", home_offset[Y_AXIS]);
+      SERIAL_ECHOLNPAIR("M206Z : ", home_offset[Z_AXIS]);
+    }
+
   #if ENABLED(MORGAN_SCARA)
     if (parser.seen('T')) set_home_offset(A_AXIS, parser.value_float()); // Theta
     if (parser.seen('P')) set_home_offset(B_AXIS, parser.value_float()); // Psi

Marlin/src/module/motion.h

@@ -78,10 +78,6 @@ extern xyz_pos_t cartes;
   #define XY_PROBE_FEEDRATE_MM_S PLANNER_XY_FEEDRATE()
 #endif
 
-#if ENABLED(Z_SAFE_HOMING)
-  constexpr xy_float_t safe_homing_xy = { Z_SAFE_HOMING_X_POINT, Z_SAFE_HOMING_Y_POINT };
-#endif
-
 /**
  * Feed rates are often configured with mm/m
  * but the planner and stepper like mm/s units.