Update Configuration.h

Marlin/Configuration.h

@@ -553,7 +553,7 @@
  *   998 : Dummy Table that ALWAYS reads 25°C or the temperature defined below.
  *   999 : Dummy Table that ALWAYS reads 100°C or the temperature defined below.
  */
-#define TEMP_SENSOR_0 1047
+#define TEMP_SENSOR_0 5
 #define TEMP_SENSOR_1 0
 #define TEMP_SENSOR_2 0
 #define TEMP_SENSOR_3 0
@@ -671,8 +671,8 @@
  * PIDTEMP : PID temperature control (~4.1K)
  * MPCTEMP : Predictive Model temperature control. (~1.8K without auto-tune)
  */
-//#define PIDTEMP           // See the PID Tuning Guide at https://reprap.org/wiki/PID_Tuning
-#define MPCTEMP         // See https://marlinfw.org/docs/features/model_predictive_control.html
+#define PIDTEMP           // See the PID Tuning Guide at https://reprap.org/wiki/PID_Tuning
+//#define MPCTEMP         // See https://marlinfw.org/docs/features/model_predictive_control.html
 
 #define PID_MAX  255      // Limit hotend current while PID is active (see PID_FUNCTIONAL_RANGE below); 255=full current
 #define PID_K1     0.95   // Smoothing factor within any PID loop
@@ -2366,9 +2366,9 @@
 #define EEPROM_SETTINGS     // Persistent storage with M500 and M501
 //#define DISABLE_M503        // Saves ~2700 bytes of flash. Disable for release!
 #define EEPROM_CHITCHAT       // Give feedback on EEPROM commands. Disable to save PROGMEM.
-#define EEPROM_BOOT_SILENT    // Keep M503 quiet and only give errors during first load
+//#define EEPROM_BOOT_SILENT    // Keep M503 quiet and only give errors during first load
 #if ENABLED(EEPROM_SETTINGS)
-  #define EEPROM_AUTO_INIT  // Init EEPROM automatically on any errors.
+  //#define EEPROM_AUTO_INIT  // Init EEPROM automatically on any errors.
   //#define EEPROM_INIT_NOW   // Init EEPROM on first boot after a new build.
 #endif