Update Configuration.h

Marlin/Configuration.h

@@ -1005,7 +1005,7 @@
  *
  * See https://github.com/synthetos/TinyG/wiki/Jerk-Controlled-Motion-Explained
  */
-#define S_CURVE_ACCELERATION
+//#define S_CURVE_ACCELERATION
 
 //===========================================================================
 //============================= Z Probe Options =============================
@@ -1246,8 +1246,8 @@
 #define Z_PROBE_LOW_POINT          -2 // Farthest distance below the trigger-point to go before stopping
 
 // For M851 give a range for adjusting the Z probe offset
-#define Z_PROBE_OFFSET_RANGE_MIN -20
-#define Z_PROBE_OFFSET_RANGE_MAX 20
+#define Z_PROBE_OFFSET_RANGE_MIN -9
+#define Z_PROBE_OFFSET_RANGE_MAX 9
 
 // Enable the M48 repeatability test to test probe accuracy
 //#define Z_MIN_PROBE_REPEATABILITY_TEST
@@ -1322,7 +1322,7 @@
 // @section extruder
 
 // For direct drive extruder v9 set to true, for geared extruder set to false.
-#define INVERT_E0_DIR true
+#define INVERT_E0_DIR false
 #define INVERT_E1_DIR false
 #define INVERT_E2_DIR false
 #define INVERT_E3_DIR false
@@ -1572,7 +1572,7 @@
   // For Cartesian machines, instead of dividing moves on mesh boundaries,
   // split up moves into short segments like a Delta. This follows the
   // contours of the bed more closely than edge-to-edge straight moves.
-  #define SEGMENT_LEVELED_MOVES
+  //#define SEGMENT_LEVELED_MOVES
   #define LEVELED_SEGMENT_LENGTH 5.0 // (mm) Length of all segments (except the last one)
 
   /**
@@ -1667,7 +1667,7 @@
 #endif
 
 // Add a menu item to move between bed corners for manual bed adjustment
-#define LEVEL_BED_CORNERS
+//#define LEVEL_BED_CORNERS
 
 #if ENABLED(LEVEL_BED_CORNERS)
   #define LEVEL_CORNERS_INSET_LFRB { 30, 30, 30, 30 } // (mm) Left, Front, Right, Back insets