jessikitty/Marlin
1
0
Fork 0
Code Issues Pull Requests Actions Packages Projects Releases Wiki Activity

Set to raptor 2 default

Browse Source
This commit is contained in:
InsanityAutomation
2019-09-28 12:29:22 -04:00
parent 39a3dc998a
commit aa10268ea7
2 changed files with 8 additions and 8 deletions
Download Patch File Download Diff File Expand all files Collapse all files
Marlin/Configuration.h
+5 -5
View File
@@ -6,7 +6,7 @@
// Enable this is you have a raptor 2.
// Selects pin file, runout sensor and stock TMC Drivers automatically
//#define RAPTOR2
#define RAPTOR2
/**
* Enable if you replace the stepper drivers with TMC 2208. Be sure to remove MS3 jumper
@@ -15,14 +15,14 @@
* you require Linear Advance with a TMC2208 on the extruder!
* If you have used a UART connection to program the driver to SpreadCycle mode, pease seect that as well
*/
#define X_2208
//#define X_2208
//#define X_SpreadCycle
#define Y_2208
#define Y_SpreadCycle // Highly recommended as large prints with high mass can cause layer shifts with stealthchop at high speed
//#define Y_2208
//#define Y_SpreadCycle // Highly recommended as large prints with high mass can cause layer shifts with stealthchop at high speed
//#define Y_4988 // Some machines shipped with 4988 drivers across the board. Set this if you arent sure what you have and all the drivers look identical
//#define Z_2208 // NOT Recommended! Dual stepper current draw is above the recommended limit for this driver
//#define Z_SpreadCycle
#define Z_4988 // Some machines shipped with 4988 drivers across the board. Set this if you arent sure what you have and all the drivers look identical
//#define Z_4988 // Some machines shipped with 4988 drivers across the board. Set this if you arent sure what you have and all the drivers look identical
//#define E_2208 // Not Recommended! Stealthchop mode faults with linear advance
//#define E_SpreadCycle
Marlin/Configuration_adv.h
+3 -3
View File
@@ -1361,12 +1361,12 @@
* Useful to get probe points to exact positions on targets or
* to allow leveling to avoid plate clamps on only specific
* sides of the bed.
*
*
* If you are replacing the prior *_PROBE_BED_POSITION options,
* LEFT and FRONT values in most cases will map directly over
* RIGHT and REAR would be the inverse such as
* RIGHT and REAR would be the inverse such as
* (X/Y_BED_SIZE - RIGHT/BACK_PROBE_BED_POSITION)
*
*
* This will allow all positions to match at compilation, however
* should the probe position be modified with M851XY then the
* probe points will follow. This prevents any change from causing